backmobil
®
Caution!
The backmobil
and release button can get very hot. Always use
an ovencloth, oven gloves or similar.
Pulling out:
Press the release button.
Pushing in:
Push the backmobil
back in again until it
slots in position.
Cleaning and care
Cooking areas
Never use sharp or abrasive agents
Clean stainless steel hob with commercially
available stainless steel polish. Clean glass cera-
mic cooking surface, enamel hob and hotplates
with a damp cloth and a little detergent.
Remove incrustations and boiled over food
from glass ceramic cooking areas with a glass
scraper. Remove sugar and melted plastic im-
mediately while the cooking area is still hot.
backmobil
Extending the backmobil
®
Press down the lever at the bottom of
the backmobil
®
frame, extend the
backmobil
®
until it has gone beyond
the catch and lift it diagonally upwards.
Taking the backmobil
®
apart
Remove the holder rods of the slot-in
gratings first from the front and then
from the back holes on the frame of
the backmobil. The slot-in gratings can
then be removed.
Assembling the backmobil
®
Insert the holder rods of the slot-in gra-
tings back into the holes on the frame
of the backmobil
®
and proceed in the
reverse sequence to the sequence
used when taking the backmobil
®
apart. Push the lever into place.
Oven
From time to time the oven needs to be cleaned thoroughly.
Removing the oven door
Open the oven door as wide as it will
go.
Fold up the clamps on the door hinges.
Take hold of the oven door on the both
sides and close it slowly. When the
oven door is about half-closed, the hin-
ges will fall out of the catches. The
oven door can now be removed.
Loosen the screw to fold down the grill.
Removing the guide rail
Loosen the screws.
Remove the slot-in grating
Insert the guide rail into the oven
Screw on the guide rail.
Ajustment of the guide rail:
The running speed of the backmobil
can be changed by tuning the
adjusting screw: normal - slow - fast
To fold down heating element (top
heat/grill)
Loosen the screws and fold down the
heating element.
Fold up the heating element again and
fasten with a screw.(special accessory
no. 600)
Reassembling the oven door
Take hold of the oven door on both si-
des and push the hinges into the rele-
vant holes on the oven.
Very slowly open the oven door.
Fold down the clamps at the door hin-
ges. Close the oven door.
Regenerating ökotherm
Heat the empty oven by intensiv hot air convection at maximum temperature
for 60 mins.
EEH 640.0
23
