EEB 6550.8
47
Attaching the oven door.
– Hold the oven door with both hands and insert the hinges in the corres-
ponding slots. The hinge should fi t snugly.
– Slowly open the door fully.
– Again lower the supports on the door
hinges.
– Close the oven door.
Model EEBK6550.8
Removing the oven door.
– Open the oven door fully.
– Insert the safety pins in the door hinge
slots.
– Hold the oven door with both hands and almost fully
close it.
– Slightly lift the door and remove hinges from the slots by pulling them
forward.
Caution. Danger of injury. Do not remove
the safety pins from the holes. The hinge is
tightened. The hinge must be tightened when
assembling. After removing the pins it is
impossible to tighten and secure the hinge.
Attaching the oven door.
– Hold the oven door with both hands and insert the hinges in the
corresponding slots. The hinge should fi t snugly.
– Slowly open the door fully.
Shelf runner assembly and disassembly
Removing the shelf runners
– Remove the shelf runners by loosening them from the chrome nuts that
are located on the sides of the oven.
– Remove the shelf runner.
Assembling the shelf runners
– Position the shelf runners and attach the nuts.
Folding down / away the heating element
Fold down the heating element (Top heat /Grill)
– Open the lock and fold down the
heater element.
Fold away the heating element.
– Fold away the heating element and
close it again with the lock.
Regeneration of the ökotherm®
catalyst
The ökotherm® catalyst dissolves the grease particles and smells
produced when roasting with the Hot Air cooking setting. This process is
suffi cient with the normal use of the Hot Air setting. In special cases
(well-cooked roasts in large quantities) it is possible that small grease
particles will be deposited on the catalyst. When you use the oven again
e.g. when cooking a pizza, they will be gradually dissolved.
If you believe that the catalyst is not cleaning as well as it should
(it smells a lot) you can regenerate it by eliminating the remains of
accumulated grease.
Regeneration of the ökotherm® catalyst
– Select the Hot Air service function.
– Set the thermostat to 200° C and
– heat the empty oven for 60 mins.
