Kuppersbusch GKS 324.0-54, Руководство пользователя

Страница: 7 / 25

H2-120-01-01 7
For internal use only
2. Installation Conditions and Assembly
2.1 Notes regarding Installation
♦
The room where the appliance is installed should have a volume of at least 20 m
3
and it must be
possible to ventilate it by a window or a door opening out into the fresh air.
♦
The hob is built into an opening in the worktop. This opening must be prepared according to the
installation dimensions specified below.
♦
The worktop must be aligned horizontally. Make a clean cut into it for the opening.
♦
There must be no cross bars beneath the opening. They should be cut back to at least the size of
the opening in the worktop.
♦
The distances at the front, rear and sides of the hob opening must conform to the measurements
shown in the drawing. The edges at the front and the rear are based on a worktop depth of 600mm.
The rear edge will be wider for worktops with a greater depth.
♦
We recommend protecting the cut surfaces of the worktop opening with a coat of waterproof paint.
♦
To ensure ease of operation at the hob, tall cupboards at the side should be at least 300 mm away.
♦
The air for the burner is supplied through ventilation slits at the back of the control panel.
♦
Additional space for the gas connection is required below the hob.
♦
The wall connection strip must be made of heat-resistant material and must have no sockets in the
area around the hob. We recommend using a support strip made of plastic with a covering strip
made of aluminium. The lateral part on the worktop must not be longer than 30mm.
♦
The wall above the wall connection strip in the area around the appliance must be made of non-
inflammable material. Wood, plastic, PVC foil etc. are not suitable.
♦
In normal use very high temperatures may act on the surrounding items of furniture. The plastic finish
or the veneer of built-in kitchen furniture must be protected by a heat-resistant adhesive (100°C).
♦
Cooker hoods and wall cupboards above the hob must be installed at a minimum distance of
650 mm.
♦
Before installing the hob and any time that the hob is removed, the gasket should be checked for
signs of damage and to ensure that it fits perfectly. Fit a new gasket if necessary. Do not use any
additional adhesives such as silicone, as there is a danger that plastic-coated worktops could be
damaged when the hob is removed.
♦
Exception: Uneven worktops (e.g. worktops with ceramic tiles) require a gasket made of a heat-
resistant, permanently elastic sealing material (e.g. with silicone, suitable for ceramic surfaces).
Only apply this sealing material around the edge of the hob, never underneath it!