32
Instructions for assembly
GB
Bracket
• Insert the hob and align it.
• From the bottom, insert the brackets with screws in the holes
provided for fastening the brackets, align the brackets and
screw them tight.
• Tighten the screws with a hand screw driver only; do not use a
battery-operated screw driver.
• In the case of thin worktops make sure that the brackets are
correctly positioned.
Important:
There is a risk of breakage if the hob is canted or subjected
to stress during installation!
Minimum distance to adjacent walls
Opening dimensions
Outer dimensions of the hob
Cable routing in rear wall
Installation height
Electrical connection
• The electrical connection must be carried out by a quali-
fied electrician who is authorised to carry out such work!
• Statutory regulations and the connection specifications issued
by the local power supply company must be strictly observed.
• When connecting the appliance it must be ensured that there
is a device which makes it possible to disconnect it from the
mains at all poles with a contact opening width of at least
3 mm. Line-protecting switches, fuses or contactors are suita-
ble cut-out devices.
When connecting and repairing the appliance disconnect it
from the electricity supply with one of these devices.
• The earth wire must be sufficiently long so that if the strain
relief fails, the live wires of the connecting cable are subjected
to tension before the earth wire.
• Any superfluous cable must be removed from the installation
area beneath the appliance.
• Make sure that the local mains voltage is the same as the volt-
age on the rating label.
• Full protection against accidental contact must be ensured on
installation.
• Important! Incorrect connection may result in the power
electronics unit being destroyed.
