Operation
GB
25
Multi-circuit operation
1. Switch on the hob.
2. Select the desired cooking level 1-9.
3. Press the
multi-circuit key
until the control lamp above the key
blinks.
4. Then immediately press the
Plus key
or the
Minus key
of
the
respective cooking zone or keep it pressed to activate additional heating
circuits.
Important:
Activating additional circuits with the
Plus key
or the
Minus key
will only function as long as the
control lamp blinks
!
Notes
• In addition to the power level display the symbols for the second or third
activated heating circuits will light up.
• Manually activated heating circuits will automatically be deselected when
the cooking zone is switched off.
STOP function
The cooking process can be briefly interrupted with the STOP function, e.g. if
the doorbell rings. The STOP function must be released in order to continue
cooking at the same power level. If a timer has been set it will pause and will
then continue.
This function is only available for 10 minutes for reasons of safety. The hob
will then be switched off.
1. Pots and pans are on the cooking zones and the required power levels
have been set.
2. Press the
Stop key
. The letters S-T-O-P will be shown one after
another instead of the cooking levels previously selected.
3. The interruption is ended by firstly pressing the
Stop key
and
then
pressing
any other key
(except the ON/OFF key).
The second key must be pressed within 10 seconds, otherwise the hob
will switch off.
Locking
The lock can be used to lock key operation and cooking level settings. Only
the Off key can be used to switch the hob off.
Activating the lock (while cooking):
1. Press the
Lock key
to activate the function. The control lamp above
the Lock key will light up. The controls are locked.
Switching off the lock
2. Press the
Lock key
to deactivate the function. The control lamp
above the Lock key will go off.
Notes
• An activated lock will remain activated even if the hob is switched off. It
must therefore be de-activated when cooking is re-commenced.
• In the event of a power cut the lock will be cancelled, i.e. deactivated.
must blink
