Kuppersberg GL4505, Технический паспорт

Страница: 4 / 44

4
Technical passporT english
dishwasher
In the event of problems, contact the dealer or
your nearest After sales Service.
The appliance must be disconnected from
the power supply before any installation
operation.
During installation, make sure the appliance
does not damage the power cable.
Only activate the appliance when the
installation has been completed.
Connection to the mains water supply must
be carried out by a qualified technician in
compliance with the manufacturers instructions
and applicable local safety regulations.
The appliance is to be connected to the
water mains using new hose sets. The old
hose-sets should not be reused. All hoses must
be securely clamped to prevent them coming
loose during operation. All local waterboard
regulations must be complied with. Water
supply pressure 0.05 - 1.0 MPa.
The inlet water temperature depends on the
dishwasher model. If the installed inlet hose
is marked «25°C max», the maximum allowed
water temperature is 25°C. For all other models
the maximum allowed water temperature is
60°C.
Do not cut hoses and, in the case of
appliances fitted with a waterstop system, do
not immerse the plastic casing containing the
inlet hose in water.
If hoses are not long enough, contact your
local dealer.
Make sure the inlet and drain hoses are
kink-free and are not crushed. Before using the
appliance for the first time, check the water
inlet and drain hose for leaks.
During use, the access to the rear wall
should be limited in a sustainable manner
such as approaching the device to the wall or
furniture board.
When installing the appliance make sure
that the four feet are stable and resting on the
floor, adjusting them as required, and check
that the appliance is perfectly levelled using
a spirit level.
If installing the appliance at the end of a
row of units making the side panel accessible,
the hinge area must be covered to prevent risk
of crushing.
For dishwashers having ventilation
openings in the base, the openings must not
be obstructed by a carpet.
ELECTRICAL WARNINGS
For installation to comply with current
safety regulations, an omnipolar switch with
minimum contact gap of 3mm
is required and the appliance must be
earthed.
If the power cable is damaged, replace
with an identical one. The power cable must
only be replaced by a qualified technician in
compliance with the manufacturer instruction
and current safety regulations. Contact an
authorized service centre. If the fitted plug is
not suitable for your socket outlet, contact a
qualified technician. The power cable must be
long enough to connect the appliance, once
fitted in its housing, to the main power supply.
Do not pull the power supply cable.
Do not use extension leads, multiple sockets
or adapters.
Do not operate this appliance if it has a
damaged mains cord or plug, if it is not working
properly, or if it has been damaged or dropped.
Keep the cord away from hot surfaces. The
electrical components must not be accessible
to the user after installation. Do not touch the
appliance with any wet part of the body and do
not operate it when barefoot.
CORRECT USE
The water in the dishwasher is not potable.
The maximum number of place settings is
shown in the product sheet.
The door should not be left in the open
position since this could present a tripping
hazard. The open dishwasher door can only