Kuppersberg FV6TGRZ, Технический паспорт

Страница: 13 / 44

13
english Technical passporT
gas hob
7.2. BASIC SETTINGS
7.2.1. FOR GAS BURNERS
Operation of the burners and power levels
Turn the control switch left-wise
until reaching to maximum level. When
you press the control switch all burning
igniters will have ame to burn. Release
the switch in few seconds after burning
of the burner, and bring the control switch
to the desired ame position between the
maximum and minimum levels.
Closing the burners
Turn the control switch right-wise to
close the hob.
Flame Failure Device (FFD)
All burners on your hob are equipped
with Flame Failure Device system against
ame extinguishing risk (water ow, wind
etc.) When the ame was gone while the
burner switch is open such system will
prevent cutting of the gas supplied to the
burner. If the burning of the burner will
be cut due to safety, repeat the burning
operation by switching the burner switch
to off position.
Figure 8.
Using Right Burner
Â
The pan diameter and the
burner power should match in order to
ef ciently use it. The diameters proper
for each burner are given in the table.
Â
Select the proper pan diameter
and volume in order to de ne the
proper burner.
If the ame is gone when you release
the switch You should repeat the above
process. But this time press the switch
and hold for about 10 seconds.
WARNING:
Do not use burning
system more than 15 seconds. If the
burner will not be burned within such
time or if the ame will be cut for any
reason whatsoever, repeat burning
process after waiting for 1 minute.