Kuppersberg FV6TGRZ, Технический паспорт

Страница: 15 / 44

15
english Technical passporT
gas hob
Â
In the event of any re do not
attempt to extinguish the ames with
water. Close the electric circuit of the
hob and use a material to cut the ame
like ame blanket.
Â
This device should not be
operated with a timer or a remote
control.
Â
Use at sole pans on the hob. In
this manner, thermal energy shall be
used to the maximum.
Â
It is recommended not to use
concave pans.
Â
Use dry sole pans on the burner.
Do not place the cover of the pan and
especially the wet ones on the burner.
Â
Use a wet cloth to wipe the hob.
However, if it becomes dirty, use water
with detergent to insure drying, apply
lubrication oil over it for formation of
thin oil substrate.
Â
If the surface of the plates worn
a few drops of oil or maintenance
products available in the market may
be used.
Â
It is recommended to set
maximum level at the beginning of
cooking process and to use intervals and
burning levels as per the characteristic
and quantity of the foods to be cooked.
Warning
Â
Do not leave the equipment
unattended since the heat of burners is
very high, and make sure that it will not
be operated by children.
Â
Pay attention for combustion risk
in the event of cooking with vegetable
oil and fats.
Â
Do not approach the hob with
combustible and explosives.
8. MAINTENANCE AND
CLEANING
Please comply with the following
rules before cleaning and maintenance.
Â
Close the unit for safety purposes.
If your device is set to natural gas
setting close the valve. For LPG hobs
close hood.
Â
Take out the plug of your unit
from wall socket.
Â
If the hob is hot wait until it will
be cooled.
Â
In order that you use the glass
hob and grills for longer periods you
need to clean them with appropriate
cleaning agents at certain intervals.
Â
Cleaning on stainless surfaces
should be conducted in accordance
with the steel surfaces, and the surface
should be dried preferably with a soft
leather part.
Â
In order to avoid any damage to
the burning system do not use burning
system when the burners are not
installed.
Â
After the thermo-coupled
cleaning providing plug and safety
system, clean it to place burners in
suitable manner.
Â
Wash the upper burning heads at
certain intervals with water and clean
and dry the gas channels with brush.
Pay attention to install the burning
heads on their places.