Kuppersberg FA60RC, Технический паспорт

Страница: 30 / 60

30
TECHNICAL PASSPORT ENGLISH
Electric hobs
11
ENGLISH TECHNICAL PASSPORT
Electric Hob
if the lock function is activated (pilot
light 9 on). When you reconnect the
cooker using the touch button (1), to
be able to operate the touch control you
must first deactivate the lock function
by pressing the touch button (7)
again.
CHILD SAFETY
This function prevents children from
connecting the appliance deliberately
or accidentally.
The safety function must be
activated after the appliance has been
connected, following the steps in figure
A. Firstly press the on button (step 1).
Then simultaneously press the touch
GB 61401288_GB_Maquetación 1
31.05.2013 14:16 Page 22 buttons
and shown in the figure (step 2).
Next, press the power increase button
(step 3). The touch buttons that
you need to press vary depending on
whether the appliance has four or five
hot plates.
Figure A:
Once the function is activated, an
L
(for Locked) will appear on the power
displays (16), to show that the control
panel is locked.
The electronic control will remain
locked, even after the control has been
disconnected using touch button (1),
as long as the user does not unlock it.
Unlocking to cook
If you want to unlock the touch
control to cook, press the touch button
(1) to activate the touch control.
Then straight away press the touch
buttons and (3/4) simultaneously,
following steps 1 and 2 in figure A.
The
L
will disappear and you can
operate the panel as usual. When you
disconnect the control using the off
button (2), the safety function will be
reactivated and it will appear again the
next time the touch control is activated.
Cancelling the safety function
The safety function must be
deactivated after the appliance has
been connected, following the steps in
figure B. Firstly press the on button (step
12
TECHNICAL PASSPORT ENGLISH
Electric Hob
1). Then simultaneously press the touch
buttons and shown in the figure
(step 2). Next, press the power decrease
button (step 3). The touch buttons
that you need to press vary depending
on whether the appliance has four or
five hot plates.
When the control is reactivated, the
appliance will be ready to start cooking.
In the event of a power cut, the lock
function (if activated) will be cancelled.
Figure B:
Power surges
When the touch control system is
subjected to a higher voltage than the
usual ranges allowed in power grids,
the hot plates will disconnect and a
continuous beep will be heard. The
following message flashes on the hot
plate displays *:
400
When the nominal voltage is
reestablished, the beeping stops and
the message on the displays disappears.
The hot plates remain disconnected and
the
H
indicating residual heat remains
on the displays if these were on before
the surge. The appliance is then ready
to be used.
The touch control detects these
power surges whenever the appliance is
connected to the mains, even if it is not
being used at that moment. The alarm
described above might therefore be
activated even when the touch control
is switched off.
Unusually high power surges can
damage the control system (like with
any electrical appliance).
Tips for using ceramic hot
plates
Â
Use pots and pans with a heavy
and completely flat base.
Â
Pans with a smaller diameter
than the shown heated area are not
recommended.
Â
Do not slide pots and pans over
the glass because they could scratch it.
Â
Although the glass can take
knocks from large pots and pans
withoutsharp edges, try not to knock it.