Kunft KWH4209, Инструкция по эксплуатации

Страница: 6 / 25

10 11
KWH4209
2. OPERATING INSTRUCTIONS
2.1. Product Description
Remote Control Instruction Panel
Week day
Heat
Lock
Clock
Temperature
Mode
Time
ECO mode
Program
‘Window open’
sensor
Program button Mode button
Lock button
“+” button “-” button
Power button
Button instructions
1. “ ” button: to turn the appliance ON or OFF
2. “+” button: to increase the temperature and timer (hold “+” into the
cycle of weekly timer)
3. “-” button: to increase the temperature and timer (hold “-” to confirm
the weekly timer)
4. “mode button”: to change the mode to I, II, ECO (hold the Mode
button to switch the window sensor off or on)
5. “PROG” button: to set the week day and timer
6. “Lock” button: hold the button to lock and unlock the remote control.
EN
wall mounted heater
2.2. Product usage
Features
• PTC ceramic heater elements, high efficiency heating, quick heating,
noiseless, odour-free, non-polluting, no flame and environmentally
harmless (it will not kill the oxygen).
• Two heating levels so you can set the temperature according to
your preferences.
• There is temperature fuse due to the danger of overheating and
a motor overheat protection. It automatically turns off when the
air outlet is blocked and turns on again when the blockages are
cleared away.
• Natural / hot air selection. You may close the heating element in the
summer so that the heater can blow cool air.
• Safety thermostat for overheat protection.
Installation
• Drill two holes on the wall about 1.8 m from the ground. The
diameter of the hole should be wide enough to contain the inflated
plastic pipe, which has a diameter of 6 mm.
• After tucking in the inflated plastic pipe, fix the hook on the pipe
with a screw. Please make sure the hook is fully inserted, as below
picture.
Heater instructions
• Remove all packaging and place the heater in your desired location.
• Unwind the power cord and plug it into the power outlet.
• Press the “ ” button; the LCD display will turn on and the heater
will switch on; press again the button again and the heater will
switch off.
• Press the MODE button: to change the mode to I, II, ECO; I for
low power, II for high power, ECO to keep the room temperature at
18ºC. When the temperature sensor reaches the room temperature