Kunft KWH4209, Инструкция по эксплуатации

Страница: 5 / 25

8 9
KWH4209
• If this product is used for other purposes
than the ones originally intended, or if it is
not correctly connected, the product may
become damaged and the warranty will be
voided.
• The heater should be hung on the wall and
the air outlet placed down or placed on a
flat surface. You must not place it precipi-
tately or tipsily.
• Please do not use the heater in a room
with combustible or explosive gases and
do not cover the air outlet.
• If the supply cord is damaged, it must be
replaced by the manufacturer or its service
agent or a similarly qualified person in or-
der to avoid a hazard.
• The heater must not be located immediate-
ly below a power outlet. Please make sure
the power outlet is equipped with an ear-
th connection with a capacity of 220-240
V, 50-60 Hz. Then check if the socket and
plug are well connected.
• When repairing the heater, please unplug
it from the socket.
• Please do not touch the heater with your
hands wet.
• If the motor is malfunctioning, please stop
it immediately.
• While using the heater, please do not con-
tinually open the door or window, otherwi-
se it will influence the heating effect.
• If you want to close the machine, press the
on/off switch to off. The machine will then
keep the fan working for 30 seconds until
it blows the cool air. After that the machine
will stop working, and you may disconnect
it.
• The heater should be hung on the wall but
far away from water or bathrooms.
• The timer sets the heater working hours.
• For the remote control, please use two
batteries. These should be removed from
the appliance before they are worn out and
then disposed safely.
• The heater should be installed at least 1,8
m above the floor, and in a way that the
switches and other controls cannot be tou-
ched by a person in the bath or shower.
CAUTION: Some parts of this product can
become very hot and cause burns. Particu-
lar attention has to be given where children
and vulnerable people are present.
To fix the heater on the wall it need two ac-
tions (insert and slide)
EN
wall mounted heater