10
11
KDD2529
1.
With the refrigerator on its back, use a
screwdriver to remove the four screws from
the cover on the top of the refrigerator.
2.
Unscrew and lift the cover from the top and
remove it. Then, lift the top door and place it
on a padded surface to avoid scratching.
3.
Remove the center of the upper hinge, move
it to the left side and press firmly.
4.
Remove the double beaded screw and then
the middle hinge that fastens the lower door.
Lift the lower door and place it on a padded
surface to avoid scratching.
EN
refrigerator double door
9.
Reinstall the top cover by inserting the upper
hinge pin into the hole of the upper door, and
secure it with the four screws. Reinstall the
screw covers.
5.
Remove the covers from
the hinge holes on the
right sides, as shown, and
transfer them to the holes
found on the left.
6.
Loosen the screws and remove the two
adjustable feet and also the lower hinge
support.
7.
Unscrew and remove the
lower hinge pin, turn the
support and refit the pin.
Reinstall the support fitting
into the bottom hinge pin.
Starting Up and Temperature Regulation
Insert the power plug into a grounded power outlet. When the
refrigerator compartment door is opened, the internal lighting is
switched on.
The temperature control knob is located on the right side of the
refrigerator compartment.
Position 0:
off. Turn in a clockwise direction
and the refrigeration unit will turn on and will
run automatically afterwards.
Position 1:
highest temperature, warmest setting.
Position 7 (last):
lowest temperature, coldest setting.
Notes:
• The 2, 3 or 4 settings are suggested if a lower or higher temperature
is required. Adjust according to your preference. Place the regulator
in the lower position, it will increase energy efficiency. Other
positions require higher energy consumption.
• High ambient temperatures (e.g. on hot summer days) and a
cold setting (position 6 to 7) may cause the compressor to run
for long periods of time or even non-stop. This is because when
the temperature is high, the compressor must run continuously to
maintain a low temperature within the appliance.
• The temperatures of the refrigerator and freezer compartments
cannot be regulated independently.
• If the ambient temperature is low, about 16
°
C, you must select
position “3” or “4”. With ambient temperatures of about 25
°
C, you
should select the “2” position.
• If a lower temperature is required, select positions “3” or “4”. With
these settings, it is guaranteed that fresh food is safely frozen and
that the freezer compartment is always at a temperature of -12
°
C.
• If fresh food needs to be frozen quickly, select position “7”, but make
sure that the temperature of the refrigerator compartment does not
drop below 0
°
C. You should also place the temperature regulator
back to “3” or “4” as soon as possible.
8.
Rotate the hinge a half turn and then transfer
it to the appropriate position on the left. Insert
the middle hinge pin into the upper hole of the
lower door, and then tighten the bolts. Transfer
the upper door to the proper position. Secure
the door’s level; insert the middle hinge pin
into the lower hole of the upper door.
Reinstall the two adjustable feet. Transfer the lower door to the
proper position. Secure the door’s level, insert the bottom hinge
pin into the lower hole of the door, and then tighten the bolts.
