18
19
KCF5215
KCF5216
chest freezer
EN
Notice:
After using the appliance for a long term, there may be a certain degree
of wear with the hinge, and it will cause some noise when opening/
closing the door and reduce the hinge’s service life. It is recommended
to regularly grease the hinge for proper maintenance, as this can
effectively eliminate noise and extend the hinge’s service life.
Temperature Control
Recommended gear
COOLING
FREEZING
POWER
• Please connect the chest freezer to a power
socket; the “POWER” lamp will light up
(green light).
• Rotate the thermostat knob clockwise; the
temperature inside the chest freezer will
lower as you turn the knob.
• “COOLING “ means cooling zone,
“FREEZING” means freezing zone.
• “Recommended gear” - see the schematic
marking position
(The above picture is for reference only. The actual configuration will
depend on the physical product or statement made by the distributor.)
2.2. Product usage
Placement
Before using the freezer, remove all packaging
materials including bottom cushions and foam pads
and tapes inside the freezer, tear off the protective
film on the door and the freezer’s body.
Keep the appliance away from heat and avoid direct
sunlight. Do not place the freezer in humid or watery
places to prevent rust or reduction of insulating effect.
The freezer should be placed in a well-ventilated
indoor place; the ground shall be flat, and sturdy.
The top clearance of the freezer shall be greater than
70 cm, and the distances from both sides and rear
shall be more than 20 cm to facilitate heat dissipation.
Changing the lightbulb (optional)
Any LED lamp replacement or maintenance is intended to be made
by the manufacturer, its Customer Support Service or a similarly
qualified person.
Replacing incandescent lamps:
• Disconnect the appliance from the power supply before carrying out
the bulb replacement.
• Hold and remove the light bulb cover.
• Dismantle the old bulb by unscrewing it counter-clockwise. Replace
it with a new bulb (Max. 15W) by screwing it clockwise, and make
sure it is tightly fixed in the bulb holder.
• Reassemble the light cover and reconnect your freezer to the power
supply.
(Above images are for reference only. The actual configuration will
depend on the physical product or statement made by the distributor.)
Start using the freezer
• The freezer shall stay up for half an hour
before connecting it to a power source when
it is used for the first time.
• The freezer shall run for 2 to 3 hours before
loading fresh or frozen food; on the other
hand, the freezer shall run for more than 4
hours in summer in advance considering that
the ambient temperature is higher.
Energy saving tips
• The appliance should be located in the coolest area of the room,
away from heat producing appliances or heating ducts, and away
from direct sunlight. Please allow hot food to cool down to room
temperature before placing it inside the appliance. Please note that
overloading the appliance forces the compressor to run for a longer
period of time. Also, food that freezes too slowly may lose quality,
or spoil.
• Please make sure you wrap food properly, and wipe containers dry
before placing them inside the appliance, as this cuts down frost
from building up inside the freezer.
• The appliance’s storage bin should not be lined with aluminium foil,
wax paper, or paper towelling since liners interfere with cold air
circulation, making the appliance less efficient.
• Organise and label food to reduce door openings and extended
searches. Remove as many items as needed at once, and close the
door as soon as possible.
