KUHN EL 50 N, Руководство по сборке и эксплуатации

Страница: 25 / 32

- 23 -
TROUBLE SHOOTING
PROBLEM CAUSE REMEDY
Noisy drive when lifting Top link of 3-point hitch badly Position the top link parallel
the machine positioned/adjusted to the lower lift arms
Excessive lifting height Reduce lifting height
Noisy drive during work Machine is tilted to the front Lengthen or shorten top link to
or rear set the machine horizontally
during work. (The tractor PTO
stud and machine input shaft
must be parallel to each other
Machine insufficiently stabilized Tighten the tractor's anti-sway
and moves from side to side stabilisers
Too much power needed Too much worked ground Adjust the machine to a higher
when working in dry setting by means of the skids
conditions or the gauge wheels
Working depth too deep Make sure it is set no deeper than
necessary
Blades too worn Change the complete set of
blades so that the rotor
stays balanced.
Ground is projected Hood is badly positioned Readjust hood position
too much to the rear
Too much power needed Too much worked ground Adjust the machine to a higher
when working in humid setting by means of the skids or
conditions the gauge wheels.
Working depth too deep Make sure it is set no deeper
than necessary.
Hood clogged Open the hood so that the
ground can flow more freely.
Tilth produced is too coarse Hood too open Close the hood
Forward speed too high Reduce forward speed
Irregular mix of Insufficient working depth Adjust the skids or the gauge
vegetable residue wheels to increase the amount
of ground to be worked
Ridging across Machine jerks and jolts Make necessary adjustment on :
the pass width during work. - forward speed (reduce slightly)
- working depth (increase slightly)
- hood opening