KUHN EL 142, Руководство по сборке и эксплуатации

Страница: 44 / 52

- 42 -
Noisy drive when lifting Top link of 3-point hitch badly Position the top link parallel
the machine positioned/adjusted to the lower lift arms (page 14)
Excessive lifting height - Reduce lifting height
- Should the problem persist, dis-
engage the PTO shaft when lift-
ing the machine.
Noisy drive during work Machine is tilted to the front Lengthen or shorten top link to set
or rear the machine horizontally during
work. (The tractor PTO stud and
machine input shaft must be
parallel to each other) (page 14)
Machine insufficiently stabilized Tighten the tractor's anti-sway
and moves from side to side stabilisers
Too much power needed Too much worked ground Adjust the machine to a higher
when working in dry setting by means of the roller, the
conditions wheels or the skids (pages 22 & 26)
Working depth too deep Make sure it is set no deeper
than necessary.
Blades too worn Change the complete set of
blades so that the rotor stays
balanced.
Rotor speed (rotational frequency) Reduce rotor speed (rotational
is too high frequency) (see page 17)
Choose the appropriate rotor See important remarks
(pages 20 and 21)
Soil is thrown too far to Hood is badly positioned Alter the positions of the hoods
the rear and their flaps (page 19)
Too much power needed Too much worked ground Adjust the machine to a higher
when working in humid setting by means of the roller or
conditions the wheels (pages 22 and 26)
Working depth too deep Make sure it is set no deeper
than necessary.
Hood or rotor clogged Open the hoods so that the
ground can flow more freely.
Raise the hood flaps (page 19)
Rotor speed (rotational frequency) Reduce rotor speed (rotational
is too high frequency) (see page 17)
Choose the appropriate rotor See important remarks
(pages 20 and 21)
TROUBLE SHOOTING
CAUSE REMEDY PROBLEM