6
Issue 01 MAR.19
Step 19 - Fit Seal to Fixed Glass Panel
1. Uncoil the two ‘Glazing Wedge Seals (PlexF05),’ Insert the seals to
the outside of the enclosure, between the fixed glass panel and lip of
the metal frame, along the vertical side, and also along the bottom edge.
Inserting the glazing seal, starting at top and working downwards, trim
excess length. If tight, lubricate glazing seal with water. Do not stretch
seal when inserting, because, after cutting to length, the seal will shrink
and leave a gap.
If the seal is misshapen, soak in warm water, not boiling, for 2-3 minutes
prior to use.
Step 17 - Refit Clip-In Extrusions
2. Relocate the clip-in extrusions down the in side of each post, rotate and
press the clip-in extrusion at top, middle and bottom of each profile, to
gently press-in and reattach the extrusions down each entire length.
1. Replace the clip-in extrusions from Step 5, ensuring left and right are
correctly repositioned. (Handing shown below for example only).
Door Opening Side
Fixed Panel Side
Door Opening Side
Fixed Panel Side
Step 18 - Fit Fixed Glass Panel
1. Carefully fit Fixed Glass
Panel into slot in wall-
post, ensuring the panel is
concentric with the rail and
vertical to the wall post. Tap
the plastic profile firmly into
groove of clip-in extrusion
along full length, if this is not
done, the fixed panel glass
may interfere with the door
glass when this is installed.
(Handing shown for example
only).
Tip. Use your foot to steady
the bottom of the glass and
prevent it slipping off the
curved rail.
2. Take the Glass Patch Clamp
assemblies (DCM-85-ASM), and
place them at the top and bottom
corners of the glass at the centre of
the enclosure.
Next take the two No.6x12 Phillips
Head screws, pushing the glass as
far round as possible, ensuring the
glass is still concentric to the rails top
and bottom. Tighten the two screws
into the two clamps, ensuring the
screws engage centrally with the
two pre-drilled pilot holes in the
curved rails. Finally, ‘push fit’ the
Patch Guide Caps (M276-01) into
the two clamps.
Locate Here
Step 20 - Fit Cover Caps
1. At both top corners, fit the inner
‘Comp. Chnl. Top Caps (M56-02)’
followed by the ‘Wall Jamb Top Caps
(M56-01) and the Top Caps left and
right (M73-01 & M73-02) .’ Securing
in place with the No.4x10mm CSK
screws provided.
Step 21 - Fit Glass Door
1. Fit the glass door, by first lifting the door into
position with both sets of wheels sitting in the top
rail profile. The rail should now take the doors
weight.
