FOR MORE DETAILS AND INFORMATION, PLEASE VISIT OUR WEBSITE
WWW.KUCHT.COM
INSTALLATION GUIDE AND USER MANUAL
7
The installation of range tops designed for recreational vehicle installation must
conform with state or other codes or,in the absence of such codes,with the
Standard for recreational vehicles.ANSIA 119.2.2–1982 in the U.S.A.or CAN/CGA
Z240.4.2 in Canada.
The installation of appliances designed for recreational park trailers must conform
with state or other codes or,in the absence of such codes,with the standard for
recreational park trailers, ANSIA119.5.
Note:
Check all piping connections in the unit for leaks.Never use an open flame to
check for gas leaks.Use a soap solution,75% water,25% dishwashing soap.It is
possible for connections made at the factory to leak,due to vibration encountered in
transportation.Make certain you have checked them all,and repair any connections
that leak.
The appliance and its individual shut-off valve must be disconnected from the gas
supply piping system during any pressure testing of that system attest pressures in
excess of½ p sig.
The appliance must be isolated from the gas supply piping system by closing its
individual manual shut-off valve during any pressure testing of the gas supply piping
system at test pressures equal to or less than 1/2psig.
Gas line shut-off valve
To reduce the possibility of gas leaks,apply Teflon tape
or a thread compound approved for use with LP or
Natural gases to all threaded connections.
Connect the supplied½”threaded pipe to the units
regulator located on the back left of the unit.We suggest
using a½” female to 3/8”male fl are adapt or on the end
of the½”threaded pipe supplied.
Use a 5/8”flexible appliance connect or to connect your
gas supply to the appliance.A3 foot leng this
recommended for ease of installation but other lengths
are acceptable.Never use an old connector when
installing a new range.
Check for leaks using a leak detector or soapy water,75%
CLEARANCES
water,25% dishwashing soap.
All units must be installed in accordance to minimum rear and side wall clearances
and clearances extended verticallyabove cooking top which are state don the serial
plate (the serial plate is located on the back of the unit.)
Make sure that the wall coverings,counter tops and cabinets around the range top can
with stand temperatures of up to 200
˚
F/93
˚
C generated by the range top.
