Kubota M7131, Руководство оператора

Страница: 260 / 298

PERIODIC SERVICE 228
B
Replacing Hydraulic Oil Filter (Suction)
To avoid personal injury or death:
A
Be sure to stop the engine before changing the
oil filter cartridge.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Place the oil pan underneath the hydraulic oil filter.
2. Remove the oil filter.
3. Put a film of clean transmission oil on the rubber seal
of the new filter.
4. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, fill the
transmission oil up to the upper line of the sight glass.
6. After running the engine for a few minutes, stop the
engine, wait for 10 minutes and check the oil level
again, add oil to the prescribed level.
7. Make sure that the transmission fluid doesn't leak past
the seal on the filter.
A
To prevent serious damage to the hydraulic system,
use only a KUBOTA genuine filter.
A
Check the transmission fluid level under the following
conditions:
(1) Park the machine on a flat surface.
(2) Lower the rear 3-point hitch and front end loader.
(if equipped)
(3) Raise the front 3-point hitch. (if equipped)
(4) Disconnect the all remote control valve hoses.
(5) Shut off engine and wait for 10 minutes.
(1) Hydraulic oil filter
(2) O-ring
(1) Filling plug
(1) Sight glass (A) Oil level is acceptable within this range