Kubota M7131, Руководство оператора

Страница: 239 / 298

207 PERIODIC SERVICE
B
Checking Transmission Fluid Level
1. Check the transmission fluid level under the following
conditions:
(1) Park the machine on a flat surface.
(2) Lower the rear 3-point hitch and front end loader
(if equipped).
(3) Raise the front 3-point hitch. (if equipped)
(4) Disconnect all remote control valve hoses.
(5) Shut off engine and wait for 10 minutes.
2. Check to see that the oil level lies between the 2 lines
of the sight glass.
If the level is too low, add new oil to the prescribed
level at the oil inlet.
(See "LUBRICANTS" in "MAINTENANCE" section.)
A If oil level is low, do not run engine.
A More transmission oil may be needed for operations
with many types of large implements equipped with
hydraulic cylinder.
(For details, consult your local KUBOTA Dealer.)
B
Checking Coolant Level
To avoid personal injury or death:
A
Do not remove radiator cap while coolant is
hot. When cool, slowly rotate cap to the first
stop and allow sufficient time for excess
pressure to escape before removing the cap
completely.
1. Check to see that the coolant level is between the
"MAX" and "MIN" marks of recovery tank.
2. When the coolant level drops due to evaporation, add
soft water only up to the max level.
In case of leakage, add anti-freeze and soft water in
the specified mixing ratio up to the max level.
(See "Flushing Cooling System and Changing
Coolant" in "EVERY 2000 HOURS or 2 YEARS" in
"PERIODIC SERVICE" section.)
A
If the radiator cap has to be removed, follow the
caution above and securely retighten the cap.
A Use clean, fresh soft water and anti-freeze to fill the
radiator.
A
If coolant should leak, consult your local KUBOTA
Dealer.
(1) Sight glass (A) Oil level is acceptable within this range.
(1) Oil inlet
(1) Recovery tank
(2) Radiator cap (A) "MAX"
(B) "MIN"