. Take the cotter pin off of the pin located at the bottom of the 2-post ROPS that normally locks
the rotated seat into position. Take the long pin to rear of the cab and install between the two
pin mounting plates at the bottom of the rear window crossmember.
NOTE: In order to spin seat, the seat must be slid ALL the way forward first. Then release the
front latch and lift seat while spinning into place. Seat must come up high enough in order to
clear rear tabs for mounting seat in TLB operation position.
. Two 1” holes need to be drilled into the foot platform on the right side for the heater hoses.
Install the provided 1” grommets, then run the heater hoses down through the holes and
towards the front of the tractor.
June 2021© Kubota BX23S Deluxe ROPS Cab Installation Manual
