. Un-bolt the cab from the front and rear shipping brackets and lift the cab off of the shipping
pallet. Lift cab over tractor. Slowly lower down until the front and rear isolators contact the
mounting plates. The cab should be lowered straight down.
. Using one 5/8” x 3” bolt, heavy flat washer, and
flange nut, start the front bracket isolator
fasteners. NOTE: the heavy flat washer is used on the bottom of the isolator underneath the
bracket.
. Once all isolators are started, torque the isolator fasteners to 200 ft-lbs. The M12 rear nuts
should be torqued to 98 ft-lbs. The front bracket M14 fasteners should be torqued to 130 ft-
lbs.
. Remove lift strap and lift bolts.
. Route the wire harness from the front left A-post towards the battery. Connect the 10GA red
wire to the positive side of the battery with the provided 1/4" loop connector. Shorten wire if
necessary, install connector, then solder connect to the wire. Connect the 10GA black wire to
the negative side of the battery with the provided 1/4" loop connector. Shorten the wire if
necessary, install connector, then solder connector to the wire. The cab options are individually
fused behind the switch plate.
. Take the flasher lights from the 2-post ROPS and attach to tabs on rear of cab. Re-connect
harness to tractor harness.
June 2021© Kubota BX23S Deluxe ROPS Cab Installation Manual
