Kubota AP-SRT62, Руководство оператора

Страница: 17 / 36

13
Section 2: Adjustments
AP-SRT62, & AP-SRT76 Rotary Tillers 321-095MK
Table of Contents
7/31/17
Shank Adjustments
!
DANGER
To prevent serious injury or death:
Make adjustments to the Rotary Tiller after it has been
properly attached to a skid steer and secured with solid
supports
. Never work around or under equipment supported
by hydraulics. Hydraulics can drop equipment instantly if
controls are actuated or if hydraulic lines burst even when
power to hydraulics is shut off.
!
CAUTION
To prevent serious injury:
Always keep your feet and legs out from under the shanks
while adjusting them. It is possible for the shanks to fall
causing injury to your feet and/or legs.
1. Park on level ground and engage park brake.
Refer to Figure 2-7:
2. Operate hydraulic cylinders at the front of the loader
arms to tilt top of skid steer hitch plate until pointer on
depth indicator points to “FULL DEPTH” as shown.
3. Lower tiller until tines are resting on the ground, turn
off engine, and remove switch key to prevent
unauthorized starting.
4. If included, raise seat bar and move controls until
both are locked.
5. Use steps, grab-handles, and anti-slip surfaces
when stepping on and off the skid steer.
See Figure 3-1 on page 16.
Refer to Figure 2-6:
6. Press top of shank spring retainer together with a pair
of pliers and pull retainer up out of the shank tube
slot. Be sure to keep shank notch caught in the tube
slot to keep it from falling while removing the spring
retainer.
7. Manually raise or lower shank as needed until one of
the three notches in the shank is seated in the top
slot. Refer to
“Shank Settings” on page 14 for
detailed instructions.
8. Fasten shank in place with spring retainer clip by
inserting clip into the tube slot behind the shank until
its snaps into place.
Depth Indicator Function
Figure 2-7
37207
Shank Adjustment
Figure 2-6
37817