Kubota AP-SRT62, Руководство оператора

Страница: 18 / 36

14
Section 2: Adjustments
AP-SRT62, & AP-SRT76 Rotary Tillers 321-095MK
Table of Contents
7/31/17
Shank Settings
The shanks can only be used with pointer on depth
indicator pointing at the 2" and 4" depths
above “FULL
DEPTH”. Set shanks to dig in the ground as follows:
Shank Settings When Tilling Full Depth
Refer to Figure 2-8:
The shanks cannot be used when pointer on depth
indicator is pointing at “FULL DEPTH”. The same is true if
the pointer is pointing to 4" or 2" depths
below “FULL
DEPTH”. The shanks are not long enough to penetrate
the ground at these settings.
Shanks Settings When Tilling 4" Deep
Refer to Figure 2-9:
With tiller rotated back and pointer on depth indicator
pointing at the 4" depth
above “FULL DEPTH”, the
shanks will penetrate the ground 4 7/8" when set in the
first notch, 3 1/8" when set in the second notch, and
1 3/8" when set in the third notch.
The skid steer can travel forward or backward when tiller
is rotated back or forward to till 4" deep.
Shanks Settings When Tilling 2" Deep
Refer to Figure 2-10:
With tiller rotated back and pointer on depth indicator
pointing at the 2" depth
above “FULL DEPTH”, the
shanks will penetrate the ground 5 3/4" when set in the
third notch, 4 1/8" when set in the second notch, and
2 3/8" when set in the first notch.
The skid steer should only travel forward when tiller is
rotated back to till 2" deep. If one was to travel backwards
while tilling, the skid shoes would dig into the ground.
NOTE: The shanks can be operated at a different
depth than noted below by raising the tiller off the
ground with the loader arms. This will also change
how deep the tiller is running. Know that the depth
indicator will not give an accurate reading with skid
shoes off the ground.
Shank Depths With Tiller Set to till Full Depth
Figure 2-8
Shank Depths With Tiller Set to till 4" Deep
Figure 2-9
Shank Depths With Tiller Set to till 2" Deep
Figure 2-10
37818
37818
37818