Kubota AP-SR2772, Руководство оператора

Страница: 18 / 44

Section 1: Assembly & Set-up
Table of Contents
4/5/19 AP-SRF2772, AP-SRF2790, AP-SR2772, & AP-SR2790 Powered Rakes 321-120MK
14
Hook-Up Powered Rake
DANGER
!
To avoid serious injury or death:
A crushing hazard exists while hooking-up and unhooking the
attachment. Do not allow anyone to stand between attachment
and power machine while approaching or backing away from
the attachment. Do not operate lift and/or tilt controls while
someone is near the power machine and/or attachment.
WARNING
!
To avoid serious injury or death:
Check hitch fit-up frequently. An improper fit-up can cause the
attachment to come loose from the loader hitch plate and fall.
Refer to Figure 1-4 & Figure 1-5:
1. Check for and remove all debris in the skid steer
universal quick attach hitch and rake hitch plate.
2. Raise lock pins on skid/loader mounting hitch plate.
3. Drive skid steer slowly up to and centered on the rake
hitch making sure the universal quick attach hitch is
parallel with rake hitch top angle bars.
4. Rotate top of skid steer tilt arms slightly forward.
5. Position top of skid steer universal quick attach hitch
under the rake top angled bars. Slowly raise loader
arms up until top of universal quick attach hitch is
seated under the top angle bars.
6. Rotate top of skid steer universal quick attach hitch
back until its hitch plate makes full contact with the
rake hitch plate.
7. Shut skid steer down properly. Refer to “Skid Steer
Shutdown” on page 18.
8. Lower lock pins on universal quick attach hitch. Make
sure lock pins go through bottom slots in rake hitch
plate and are in the locked down position.
Hydraulic Hose Hook-Up
WARNING
!
To avoid serious injury or death:
Make sure hydraulic hoses are properly routed without twists
to prevent becoming stretched, pinched, or kinked. A damaged
hose can burst and leak hydraulic fluid.
•
Hydraulic fluid under high pressure can penetrate the skin
and/or eyes causing a serious injury. Wear protective gloves
and safety glasses or goggles when working with hydraulic
systems. Use a piece of cardboard or wood rather than
hands when searching for leaks. A doctor familiar with this
type of injury must treat the injury within a few hours or
gangrene may result. DO NOT DELAY.
•
Make sure hydraulic flow to the attachment does not exceed
maximum rated flow listed in the specifications. Exceeding
maximum flow will increase rotor speed and result in a
thrown object hazard.
IMPORTANT: Make sure coupler fittings are clean
before making connections. Dirt can quickly damage
the hydraulic system. Inspect couplers for corrosion,
cracks and excessive wear. Replace couplers if any
of these conditions exist.
SRF27 Series Hook-Up Powered Rake
Figure 1-4
SR27 Series Hook-Up Powered Rake
Figure 1-5
39953
Top Angle Bars
Bottom Slots
39765
Top Angle Bars
Bottom Slots