CAB INSTALLATION
7 of 29
STEP 2: (SEAL KIT)
Seal Kit is included on Premium Cabs only.
Note: the flattest side of the flex brush should face
down for best fit and finish. Bristles to butt up against
each other with NO gaps or overlap unless otherwise
stated. When drilling, do not press down too hard.
Denting or puckering may occur if too aggressive.
2.1
Install (2)
6”
long flex brushes (item
“
A
”
in fig 2.1a)
to the underside of the left floorboard mount, using (4)
plastic tree clips. See figures 2.1a and 2.1b.
Note: the
(2) brushes on the floorboard mount do overlap.
2.2
Remove the hardware from forward/rev pedal, set
aside the pedal and hardware. See fig. 2.2. Peel back
rubber mat.
2.3
Per figures 2.1a and 2.3, install flex brushes as
shown on the right floorboard (one
“
A
”
brush and one
“
B
”
brush). Using the hole pattern in the flex brush as a
guide, drill two holes per side
(7/32”
diameter) thru the
sheet metal floorboard.
Note: It is recommended that a
spare piece of metal is placed behind where you are
drilling to ensure no damage is done to the vehicle.
2.4
Per figures 2.1a and 2.4, install flex brushes as
shown around the differential lock lever found on the
left fender (two
“
C
”
brushes). Using the hole pattern in
the flex brush as a guide, drill two holes per side
(7/32”
diameter) thru the sheet metal fender.
2.5
Re
-
install the right side of the rubber mat in place
and remount the forward/rev pedal.
Fig. 2.1b (underside of left floorboard mount)
Fig. 2.2 (forward/rev pedal
-
right floorboard)
Fig. 2.3 (flex brush installation
-
forward/rev pedal)
Fig. 2.4 (flex brush installation
-
differential lock pedal)
drill 2 holes
per brush
5”
brushes
drill 2 holes
per brush
4”
spacing
bristles to butt up
against each other
A
Fig. 2.1a (3 flex brush sizes included in seal kit)
A
A
A
B
C
C
mounting
hardware
forward/rev pedal
B
C
6”
5”
2.4”
1.3”
1.3”
