SERVICE WORK ON THE ENGINE
75
B00330-11
–
Remove plug
with oil screen
and the O-rings.
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing surfaces.
–
Push the oil screen with O-rings on to a pin wrench.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
–
Mount and tighten screw plug
with the O-ring.
Guideline
Screw plug, oil screen
M20x1.5
15 Nm
(11.1 lbf ft)
B00329-11
–
Mount and tighten the oil drain plug
with the magnet and a new seal ring.
Guideline
Oil drain plug with magnet
M12x1.5
20 Nm
(14.8 lbf ft)
B00331-11
–
Remove screws
. Remove the oil filter cover with the O-ring.
B00332-11
–
Pull oil filter
out of the oil filter housing.
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean the parts and sealing area.
B00333-11
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓
full with
engine oil.
–
Fill oil filter with engine oil and place in the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with the oil filter cover
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover
M6
10 Nm (7.4 lbf ft)
–
Stand the motorcycle upright.
B00327-11
–
Remove the oil filler plug
with the O-ring from the clutch cover and fill up with
engine oil.
Engine oil
1.10 l (1.16 qt.)
Engine oil (SAE 10W/50) (
Alternative engine
oil for harsh oper-
ating conditions
and increased per-
formance
Engine oil
(SAE 10W/60)
(00062010035)
