KTM F8203S2, Инструкции по установке

Страница: 14 / 48

2 SETUP
12
–
Secure turn signal relay
5
with a cable tie and plug in
the connector.
–
Install the headlight mask with the headlight. ( p. 21)
S01394-10
–
Route the turn signal wiring harness from front to back as
far as the battery compartment.
–
Position and secure the turn signal wiring harness under
the rubber bands of the fuel tank contact area on the main
wiring harness.
E00494-10
–
Remove screw
6
.
–
Remove screw
7
.
–
Pull off the side cover in area
A
and in area
B
and
remove it toward the rear.
E00487-10
–
Detach spring
8
.
Spring hook (5030501700004)
–
Remove screws
9
with washers and take off main
silencer.
S01417-10
–
Pull off engine electronics control unit from the holder and
hang it to the side.
–
Disconnect and remove plug-in connector
bk
on the main
wiring harness.
–
Join the plug-in connector of the turn signal wiring harness
with the plug-in connector of the main wiring harness.