KTM 950 ADVENTURE 2004, Руководство пользователя

Страница: 36 / 57

ENGLISH
35
Replacing the headlight lamps *
Remove the 5 screws on the left and right and take off both side covers
1
.
Use a screwdriver to detach the retaining tabs
2
, tilt the windshield and
headlight forward and pull the connector off the connector support. Place
the headlight on a soft pad to keep it from being damaged.
!
CAUTION
!
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
. T
HE GLASS OF THE BULB
MUST REMAIN ABSOLUTELY FREE FROM GREASE
. H
EAT WILL OTHERWISE CAUSE THE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
.
HIGH BEAM BULB A :
Remove the rubber cap 3 and pull off the connector 4 . Detach the retai-
ning clip and remove the bulb.
Fit the retaining clip, connect the connector and mount the rubber cap.
LOW BEAM BULB B :
Remove the rubber cap 5 and pull off the connector 6 . Detach the retai-
ning clip and remove the bulb.
When inserting the new bulb, make sure tab
D is firmly seated in the
socket recess.
Fit the retaining clip, connect the connector to the bulb and mount the
rubber cap.
PARKING LIGHT BULB C :
Pull the bulb socket 7 out of the reflector and pull the bulb out of the bulb
socket.
USA design:
The parking light E is located in the upper part of the headlight in the USA
design.
E bulb F with high and low beams is mounted in the lower part of
the headlight.
Connect the connectors to the connector support to check all of the bulbs
for proper functioning before you remount the headlight.
2
1
3
4
A
B
5
6
D
C
7
E
F