KTM 690 Enduro R EU, Руководство пользователя

Страница: 62 / 105

0 0 B B
0 0 A A
MAINTENANCE WORK ON CHASSIS AND ENGINE
60
8.70
Adjusting the headlamp
–
Remove the trim. ( P. 54)
400355-10
–
On a light-colored wall in front of which there is a horizontal surface, make a mark
at the height of the center of the low beam headlamp.
–
Make another mark at a distance

below the first mark.
Specification
Distance

5 cm (1.97 in)
–
Position yourself with the motorcycle at a distance

in front of the wall and
switch the low beam on.
Specification
Distance

5 m (16.4 ft)
600102-10
–
Loosen screws

and

. Swivel the headlamp bracket

and headlamp of the
ready-to-operate motorcycle with a rider until the light-dark boundary lies exactly
on the lower mark.
–
Tighten screws

and

.
–
Mount the trim. ( P. 54)
8.71
Removing the battery
x
Warning
Risk of injury Battery acid and battery gases cause serious chemical burns.
–
Keep batteries out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
Avoid contact with battery acid and battery gases.
–
Keep the battery away from sparks or open fire. Charge only in well-ventilated rooms.
–
In the event of skin contact, rinse with large amounts of water. If battery acid gets in the eyes, rinse with water for at least
15 minutes and contact a physician.
–
Switch off all power-consuming components and switch off the engine.
–
Remove the seat ( P. 55)
600068-11
–
Disconnect the negative (minus) cable

of the battery

.
–
Pull back the plus pole cover and disconnect the positive (plus) cable

of the bat-
tery.
–
Remove screws

. Remove the retaining bracket

.
–
Lift the battery

up and remove it.