KTM 690 Enduro R 2017, Инструкции по установке

Страница: 7 / 20

2 SETUP
5
S00801-10
–
Recharge the battery. ( p. 7)
–
Plug in connector
6
on the starter relay.
S00802-10
–
Remove the rear fairing. ( p. 11)
–
Four markings
7
are found on the underside of the rear fairing. At these location,
drill holes to the specified diameter in three stages.
Guideline
Hole diameter for grab handles 14.5 mm (0.571 in)
S00803-10
–
Remove screws
8
.
–
Fit the rear fairing. ( p. 11)
700217-01
–
Mount the reflector.
S00804-10
–
Insert rubber bushings 9 in the footrest bracket.
–
Position the engine guard. Mount and tighten screws bk .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Operation as a 2-seater
–
Mount rear footrest bracket. ( p. 12)
Operation as a 1-seater (only if requested by customer)
–
Mount the rubber strap for the side stand. ( p. 12)
Warning
Forfeiture of homologation and insurance cover
The vehicle is
homologated as 2-seater. If the heel protector is fitted instead of the
footrest bracket, the vehicle no longer conforms to the homologation and
must not be operated in this form without alterations to the registration
papers.
–
Set up and operate the vehicle as a 2-seater or have changes made
to the registration papers.
–
Mount heel protector. ( p. 12)
–
Refuel. ( p. 13)