KTM 65 SX 1999, Руководство пользователя

Страница: 71 / 91

16 SERVICE WORK ON THE ENGINE
69
601967-10
Main work
–
Place a suitable container under the engine.
–
Remove gear oil drain plug  with magnet.
–
Let the gear oil drain fully.
–
Thoroughly clean the gear oil drain plug with magnet.
–
Clean the sealing surface on the engine.
–
Mount the gear oil drain plug with magnet and the seal ring and tighten it.
Guideline
Oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)
16.4 Filling up with gear oil
Info
Too little gear oil or poor-quality oil results in premature wear of the transmission.
K00212-10
Main work
–
Remove screw cap  and fill up with gear oil.
Gear oil 0.50 l (0.53 qt.) Engine oil (15W/50) ( p. 81)
–
Mount and tighten screw cap.
Danger
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Finishing work
–
Check the gear oil level. ( p. 68)
16.5 Adding gear oil
Info
Too little gear oil or poor-quality gear oil results in premature wear to the transmission.
Preparatory work
–
Stand the motorcycle upright on a horizontal surface.
300661-10
Main work
–
Remove gear oil monitoring screw

.
K00212-11
–
Remove screw cap

.
–
Add gear oil until it flows out of the hole of the gear oil monitoring screw.
Engine oil (15W/50) ( p. 81)
–
Mount and tighten the gear oil monitoring screw.
Guideline
Screw, gear oil level check M6 6 Nm (4.4 lbf ft)
–
Mount and tighten screw cap  .