ENGLISH
33
Fuses
Fuse box
A
is located under the seat.
See "Removing the seat" to remove and mount the seat.
The fuses are numbered on the inside of the fuse box.
The fuses marked "RES" are spare fuses.
Main fuse
1
(20 amperes) protects all power consumers against short
circuits.
Fuse
2
(10 Ampere) protects the following power-consuming units:
– electronic speedometer
– capacitor
Fuse
3
(10 Ampere) protects the following power-consuming units:
– ignition
– starter system
Fuse
4
(10 Ampere) protects the following power-consuming units:
– flasher lights
– brake light
– horn
Fuse
5
(10 Ampere) protects the following power-consuming units:
– headlight
– parking light
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
!
CAUTION
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
ALLOWED TO BE
“
REPAIRED
”. A
N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
ELECTRICAL INSTALLATION
!
Exchanging the headlight lamp
Replacing the headlight bulb
Remove the headlight mask:
Remove screw
1
on the left and right.
Tilt the headlight mask to the front and detach from the lower fender.
Exchanging the headlight lamp:
Disconnect plug
2
from the bulb.
Remove the rubber cap
3
Unhook the retaining bracket, then remove the bulb.
When inserting the new bulb make sure that the wider of the 3 tongues
4
is located in the corresponding groove in the socket.
!
CAUTION
!
N
EVER TOUCH THE GLASS OF THE BULB WITH YOUR FINGERS
. T
HE GLASS OF THE BULB
MUST REMAIN ABSOLUTELY FREE FROM GREASE
. H
EAT WILL OTHERWISE CAUSE THE
GREASE TO EVAPORATE AND SETTLE DOWN ON THE REFLECTOR
.
Hook in the retaining bracket, mount the rubber cap and connect the plug
to the bulb.
Mount the headlight mask:
Position the headlight mask such that the headlight is located under the
cockpit.
Fit the headlight mask into the fender and mount screws
1
.
Replacing the parking-light bulb
Disassemble the headlight as described above and simply pull the bulb
socket
5
out of the reflector.
A
1
5
3
2
4
