KTM 2009 690 Rally Factory Replica, Руководство пользователя

Страница: 48 / 104

MAINTENANCE WORK ON CHASSIS AND ENGINE
46
600063-10
–
Position brake linings

and insert bolts

by hand.
–
Position brake caliper, mount and tighten screws

.
Guideline
Screw, front brake caliper M8 30 Nm
(22.1 lbf ft)
Loctite
®
243™
–
Mount the bolt

with a suitable tool and insert the lock pin

.
–
Operate the hand brake lever repeatedly until the brake linings lie on the brake disc
and there is a tight spot.
8.43
Changing the front brake linings
x
Warning
Skin irritations
Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking due to old brake fluid.
–
Have the front and rear brake fluid replaced according to the service plan in an authorized KTM workshop.
Warning
Environmental hazard
Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
600058-10
–
Remove the front brake linings.
x
( p. 45)
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws

.
–
Remove cover

with membrane

.
–
Press the brake piston back to its basic position and make sure that no brake fluid
overflows from the brake fluid reservoir.
–
Install the front brake linings.
x
( p. 45)
600059-10
–
Add brake fluid to level

.
Brake fluid DOT 4 / DOT 5.1 ( p. 96)
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.