KTC ABX70, Инструкция по эксплуатации, Страница: 5 / 18

5
6. CAUTIONS ON USE
Before use, read the following cautions & notes and check all items.
CAUTION

This product can be used qualified persons only such as automotive
mechanics or persons with license.

Do not use for any other purpose than sending brake fluid.

Eemove the remained air from body (switch lever position
：
discharge
）
before removing/changing any part of this product.

Do not use the product and/or part if any crack and/or

deformation is noticed.

Turn switch lever to discharge (
排気
) and stop the operation if any problem
such as brake fluid leak occurred during the pressure-sending operation.

Input air pressure should be less than 10kgf/cm
2
(1.0mpa).

Stop the operation if the pressure indicates over 3kgf/cm
2
(0.3mpa).

Use the product at the temperature within 5
～
40
ﾟ
c.

Do not apply external force on attachment after installed on the reservoir.

Do not touch on the regulator as it has already adjusted for the best.

Do not pull pressure-sending hose.

Do not use deteriorated pressure-sending hose.

Do not bend pressure-sending in operation.

Do not give any impact or trail pressure-sending hose, etc. they can be
causes for trouble.

Do not disassemble or alter the product.

Use only the specified products such as pressure-sending hose.
NOTE

Work mehod on brakes should be done basen on the maitenace mamual of
each car maker.

Read instruction manual and cautions for brake fluid and fully understand
about this prodcut.

Use brake fluid specified by car maker.

Be careful not to spilt brake fluid on body.

If brake fluid spilt out, take it quickly by waste and wash with water.

Turn switch lever to neutral (
中立
) for storaging.
NOTE
（
About abs installed vehicle
）
This product can be used for abs or hydro-unit installed cars, but be careful
about the following points;
 Abs installed cars may let it’s computer work by itself and draw air into
actuator. So please do operation based on maintenance manual of each car
maker.

Hydro-unit or hydraulic booster installed cars may need to remove air from
such device it self. So please do operation based on maintenance manual
of each car maker.