KTC ABX70, Инструкция по эксплуатации, Страница: 12 / 18

12
[ HOW TO USE ATTACHMENT B1 or B2+ CLAMP E1 ]
※
Put E1 on B1 or B2 for use.
Installing method for B1,B2 is same as in the above case of B1 orB2+D1.
NOTE
･
For car models which reservoir is positined offset to the master cylinder
(Mitsubishi), please use D1.
(1) Remove the cap and strainer of the reservoir. Turn Adj. Nut clock-wise close
to the bore of the reservoir port and pooch Expansion Rubber.
NOTE
･
Do not forget to pooch Expansion Rubber, otherwise it may contact the
separator and cannot be used properly.
(2) Insert Expansion Rubber into the reservoir until Plate contacts the guard.
While pushing Plate, turn Adj. Nut clockwise until locked to make
Expansion Rubber contact closely with the reservoir port and fix.
NOTE
･
Reduce brake fluid to the minimum level or put a waste cloth on the air
coupler not to make the engine room dirty by spilt brake fluid from Plug
Coupler, etc.
(3) Put Clamp E1 on Lock Nut of B1 or B2. Hang Chain on the master
cylinder body and turn Lock nut counter-clockwise to fix Plate on the guard
of the reservoir.
NOTE
･
Be careful not to hang Chain on other lines or pipings near the master cylinder.
･
Hang chain through the lower part(metal part) of the master cylinder.
If hanged only on the reservoir, Chain may damage the reservoir.
(4) Turn Chain Adj. Nut clockwise to be locked for stretching Chain.