67
ENGINE
CLUTCH DRUM AND CERTIFUGAL CLUTCH INSTALLATION
1. Install the clutch drum (1) and the certifugal clutch (2) in re-
verse order.
2. Tighten the nut (3).
NOTE
Stick in the nut (3).
VARIOMATIC DRIVE DISC INSPECTION
1. Measure the outside diameter (A) of the rolling balls.
Allowable limit (A): 19.5 mm
2. Measure the inner diameter (B) of the movable drive face.
Allowable limit (B): 24.04 mm
3. Measure the outside diameter (C) of the sleeve.
Allowable limit (C): 23.98 mm
VARIOMACTIC DRIVE DISC INSTALLATION
1. Install the variomatic drive disc in reverse order.
See page: 54
BELT INSPECTION
1. Check whether the belt is cracking and wether the rubber and
cotton fall of or is abnormally abrased.
2. Check possible shedding or abnormal abrasion.
3. Measure the width (A) of the belt.
Allowable limit (A): 20.5 mm
BELT INSTALALTION
1. Thread the belt in the driven disc.
2. Pushing apart the driven disc and thread the beld above the
drive disc shaft.
2
1
3
C
B
A
A
Содержание T58 - ZION 125
