code R30045.110en www.kseniasecurity.com
ed.06/2022
USER GUIDE
The user can perform the following functions, the success of them depends on the system configuration.
Note:
a) when you press a key you can hear a beep feedback, if the buzzer is enabled, otherwise you can see a
blinking of keys. In case no feedback is received, repeat the operation and increase the pressure on the key;
b) you have 5 seconds between two operations (entering PIN and pressure of key). If the timer expires, just
repeat the operation.
Running a scenario from keypad
With PIN: [PIN + 0...9]
•
Enter your code and then press the key to execute the desired scenario. The RGB led will take the same
color as the programmed scenario, if it changes the arming status of the system. According to the
configuration, the RGB led can be configured always ON or turn off when the timer expires.
Without PIN: [0...9]
•
Hold down the programmed key and wait for 3 seconds to execute the scenario desired. The RGB led
will take the same color as the programmed scenario, if it changes the arming status of the system.
According to the configuration, the RGB led can be configured always ON or turn off when the timer
expires.
Incorrect PIN code
•
For recovering eventual errors while entering the PIN code, it is possible to cancel the wrong digits by
pressing <X> key.
•
Incorrect PIN code blocks the keypad for 5 minutes after the third wrong attempt.
Running a scenario from mini-Tag
Place your mini-Tag near RFID reader on the keypad (
) and then press the key that activates the desired
scenario. The RGB led will take the same color as the programmed scenario, if it changes the arming status
of the system. According to the configuration, the RGB led can be configured always ON or turn off when
the timer expires.
Cleaning the keypad
Use a soft and moistened cloth with water to clean externally the keypad.
