KSB Magnochem-Bloc, Инструкция по установке и эксплуатации

Страница: 67 / 96

7 Servicing/Maintenance
67 of 96
Magnochem-Bloc
Table 18: Design features of casing cover fastening
Bolted casing cover Clamped casing cover
102
161 902.01 902.15 344 102
161 902.01 344
7.5.5.1 Fitting the bearing bracket lantern – design with bolted casing cover
ü The notes and steps stated in ( ð Section 7.5.1, Page 59) to
(
ð
Section 7.5.4, Page 64) have been observed/carried out.
ü The individual parts are kept in a clean and level assembly area.
ü All dismantled parts have been cleaned and checked for wear.
ü Any damaged or worn parts have been replaced by original spare parts.
ü
The sealing surfaces have been cleaned.
1. For models with leakage barrier only: insert O-ring 412.98 into bearing bracket
lantern 344.
2. Place the containment shroud guard onto containment shroud 82-15.
3. Screw studs 902.15 into casing cover 161.
NOTE
On the fully assembled pump, the marking in the casing cover and the eyebolt must
point in the same direction (upwards).
4. Fit bearing bracket lantern 344 on casing cover 161.
5. Tighten hexagon nuts 920.15 to the torques given in this manual.
(
ð
Section 7.6, Page 74)
6. Remove the guard.
7. Fit studs 902.04.
7.5.5.2 Fitting the bearing bracket lantern – design with clamped casing cover
ü The notes and steps stated in ( ð Section 7.5.1, Page 59) to
( ð Section 7.5.4, Page 64) have been observed/carried out.
ü The individual parts are kept in a clean and level assembly area.
ü All dismantled parts have been cleaned and checked for wear.
ü
Any damaged or worn parts have been replaced by original spare parts.
ü The sealing surfaces have been cleaned.
1. For models with leakage barrier only: insert O-ring 412.98 into bearing bracket
lantern 344.
2. Place the containment shroud guard onto containment shroud 82-15.
NOTE
On the fully assembled pump, the marking in the casing cover and the eyebolt must
point in the same direction (upwards).