5.5.8.3 Replacement and filling of brake fluid of CBS pump
●Disassemble:
Reservoir [A]
●Disassemble:
Reservoir cover, reservoir washer
Loosen the bleed screw of slave pump of front brake
[B], and vacuumize from the bleed screw using a
vacuum pump to pump the brake fluid completely.
●Add new brake fluid to master cylinder reservoir,
keep the brake fluid in the reservoir not less than 1/3 of
its volume, and pull the brake lever for several times
quickly, and lock the bleed screw of slave cylinder [B].
○Operate the brake lever and feel. If you feel that it is
softer than before, please repeat the above actions to
refill.
。
WARNING
The precautions for handling disc brakes are as
follows:
1. It is forbidden to reuse brake fluid!
2. If the container containing the brake fluid is not
sealed or has been opened for a long time, the brake
fluid inside the container must not be used!
3. Do not mix brake fluids of different types or
brands. This will reduce the boiling point of the
brake fluid, resulting in brake failure or corrosion of
rubber brake parts.
4. Do not open the reservoir cap for a long time to
prevent the brake fluid from getting wet.
5. Do not replace brake fluid in rain or strong winds!
6. In addition to brake pads and brake discs, only
disc brake fluid, isopropyl alcohol or alcohol can be
used to clean the brake parts. Do not clean the above
parts with any other liquid! Gasoline, oil or other
- 125 -
KS MOTORCYCLES - https://ksmotorcycles.com
Содержание K-LIGHT125
