Check whether the filter element is contaminated or
damaged.
If there is any contamination and damage, please
replace it with a new one.
Clean the air filter element.
*Note
Do not use the gasoline so as not to cause fires.
Replacement time
If motorcycle often runs on bad roads or in rainy days,
it should be replaced ahead of time.
*Note
When disassembling the air cleaner core, do not
rotate the engine. Otherwise, unfiltered air may
enter the engine, thus causing rapid wear of its
components and possibly damaging the engine.In
addition, operation without the filter element may
affect subsequent adverse operation of throttle and
may cause the engine to overheat.
In addition, operation without the filter element
may affect subsequent adverse operation of throttle
and may cause the engine to overheat.
Installation
It should be conducted in the reverse order of
disassembly
*Note
•Make sure whether the air filter has been
installed before installing air filter cover.
Spark plug
Remove the connecting wire of spark plug cap.
Remove spark plug using spark plug wrench or
alternative tool
Check
.
Whether insulator is cracked or damaged
.
Whether electrode is worn
.
Burning conditions, color
If it is light gray, combustion conditions are good.
If it is pale white, ignition system is out of order or
the mixture is too thin.
If it is damp or black with carbon deposit, the
mixture is too thick.
Spark plug gap
- 56 -
KS MOTORCYCLES - https://ksmotorcycles.com
Содержание K-LIGHT125
