Krups ESPRESSO NOVO 3000, Инструкция по эксплуатации

Страница: 14 / 17

14
• After use, remove the flexible tube from the
container.
. Using the Krups patented Perfect Froth
Attachment
Krups patented Perfect Froth attachment Is
available on all models. For the FNC3 model
you will need to remove the auto-cappuccino
attachment and replace It by the Perfect Froth
Attachment in order to execute this operation
(36) .
You can use the Perfect Froth attachment to
froth milk for cappuccinos, Lattes and hot
chocolates as well as heating any liquid (water
for tea or thick liquids for soups)
•
Fill the water container (1) (2) (3) and start
the appliance (5).
•
Move the steam nozzle to the exterior of the
appliance.
•
Turn the selector to the setting (20) .
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
•
Immerse the steam nozzle in the container
holding the liquid to be heated.
•
Then turn the selector to the
setting
(21)
until the liquid is hot enough, then reset the
selector to the
O setting and remove the
container.
•
For liquids other than water, turn the
selector to the setting
(20) for the
following cleaning operation in order to
prevent any blockage of the opening of the
steam nozzle :
•
place an empty container below the steam
nozzle.
• select the
setting again
(21) to remove
the residue of the liquid.
•
turn the selector to the setting O.
•
Clean the steam nozzle with a damp cloth.
•
For more thorough cleaning of the nozzle,
please refer to the paragraph on
maintenance.
Cleaning the Machine
- Never wash your espresso machine
accessories in the dishwasher.
After use, the water container must be
emptied.
. Removable drip tray
After using the appliance, remove the
overflow grid and empty the removable drip
tray
(30) (31) . If several espressos are being
prepared one after the other, the drip tray
should be emptied from time to time (about
once every 7 - 8 espressos). If necessary, clean
the drip tray and its grid with water and a
little non-abrasive dishwashing liquid, rinse
and dry. When reassembling the machine,
ensure that the plastic lining is in the right
place
(32) .
. The brewing head, the filter basket and
the filter holder
These must be cleaned after each use. All you
need to do is wipe a damp cloth over the
brewing head of your appliance and to wash
the other accessories in water and a little non-
abrasive dishwashing liquid, rinse and dry.
If the brewing head is heavily clogged up,
unscrew the grid using a coin, clean it and
refit it, pressing down firmly
(33) .
When your espresso machine is not being
used, do not leave the filter holder in the
appliance to prevent wear on the gasket.
. The cup warming plate: remove this to
clean it with water and a little non-abrasive
dishwashing liquid, rinse and dry
(34) .
. Steam nozzle: wipe with a damp cloth after
each use.
. The auto cappuccino accessory
After each use, we recommend that you rinse
the auto cappuccino accessory in the
following manner:
•
Turn the selector to the steam pre-heating
position
(19)
.
• Turn the dial to the cleaning position (37) .
•
Immerse the flexible tube into a glass of
water. (The minimum quantity necessary is 3
to 4 ounces/30-60 ml).
• Place an empty container below the outlet
nozzle.
Once the appliance reaches the correct
temperature, the orange temperature control
light will go out.
• Then turn the selector to the steam setting
(26) .
•
When all the water has run through the