
Placing in Storage
60
Pos : 114.5 /Ü berschriften/Ü berschriften 2/A-E/Am Ende der Erntes ais on @ 0\mod_1197385501276_78.doc @ 19985
15.2
At the End of the Harvest Season
Pos : 114.6 /BA/Ei nlag erung/Sc hwader/Einl agerung allgemein @ 2\mod_1202808984326_78.doc @ 61669
Before placing the machine in winter storage, clean the outside thoroughly. If you use a high-
pressure cleaner to do this Do not keep a stream of water directed at bearing points. After
cleaning is completed, lubricate all lubrication points. Do not wipe off any grease that comes out
of
bearing
points. The hardened grease will provide additional protection against moisture.
Check all movable components such as deflector rollers, joints, tension rollers, etc. to make
certain they move easily. If necessary remove, clean, grease and remount. If necessary, replace
with new parts.
Use only original KRONE replacement parts.
Disassemble the PTO shaft. Lubricate the inner tubes and the guard tube with grease. Grease
the lubrication points on the cross joint and grease the bearing rings of the guard tube.
Repair places with damaged paint and preserve all bare metal places thoroughly with rust
protection agent.
Park the machine in a dry location, but not in the vicinity of artificial fertilisers or livestock
buildings. Repair places with damaged paint and preserve all bare metal places thoroughly with
rust protection agent.
Caution!
The machine should only be placed on blocks with a suitable vehicle lifting
device. Make certain that the machine is stable and safe when it is on blocks.
To provide relief for the tyres, set the machine on blocks. Protect the tyres against external
influences such as oil, grease, direct sunlight , etc.
Perform the necessary repair tasks during the time immediately after the harvest season. Draw
up a list of all replacement parts you will need. This will make it easier for your KRONE dealer to
process your orders and you will be certain that your machine will be ready for use at the
beginning of the next season.
Pos : 114.7 /BA/-----Seitenumbruc h------ @ 0\mod_1196175311226_0.doc @ 4165
Содержание Swadro 38 T
Страница 11: ...Introduction 11 L SW46T025 Figure 2 Pos 21 BA Sei tenumbruch 0 mod_1196175311226_0 doc 4165 ...
Страница 65: ......