KRONE Medium Operation Panel
106
Pos: 32.16 /Ü berschriften/Ü berschriften 3/A-E/A/Anzahl der N etzumwickl ung en ei nstellen_für Bedi enbox @ 330\mod_1427719473687_78.docx @ 2530496 @ 3 @ 1
7.3.2
Setting the Number of Net Layers
Pos: 32.17 /BA/Bedienung /R undballenpr esse/Bedienbox Medium_F ortima/Anzahl der Netzumwickl ungen ei nstellen_Bil d_F orti ma F @ 330\mod_1427720375644_78.docx @ 2530620 @ @ 1
FOR00082
1
3
X
2
Fig. 68
Pos: 32.18 /BA/Bedienung /R undballenpr esse/Bedienbox Medium_F ortima/Anzahl der Netzumwickl ungen ei nstellen_Text_Forti ma F @ 3 30\mod_1427720376402_78.docx @ 2530651 @ @ 1
The setting screw (1) is located on the right-hand machine side behind the side guard. The
number of net layers is set by means of this setting screw.
• Make sure that the tip (3) of spring rail is not on the setting screw.
• To loosen the counter nut (2) and to screw it out, hold the setting screw (1) by using
hexagon wrench.
Note: This is a left-hand thread!
The further the counter nut (2) is screwed out and the further the distance x is reduced, the less
the round bale is wrapped with net.
Distance x is the dimension between putting on the spring rail tip (3) and the outer edge of the
setting screw.
Pos: 32.19 /BA/Bedienung /R undballenpr esse/Bedienbox Medium_F ortima/Anzahl der Netzumwickl ungen ei nstellen_Tabelle_Forti ma F @ 330\mod_1427782217137_78.docx @ 2531175 @ @ 1
Distance x
Number of net layers
Fortima F 1250
Fortima F 1600
19 mm
23 mm
2
28 mm
34 mm
3
• Check the values from the upper table on the ejected round bale and correct them, if
necessary.
Pos: 32.20 /Layout Module /---------------Seitenumbr uch---------------- @ 0\mod_1196175311226_0.docx @ 4165 @ @ 1
