Krone ActiveMow R 200, Руководство по эксплуатации

Страница: 48 / 90

8 Operation
8.5 Mowing
48
ActiveMow R 200
Original Operating Instructions 150000521_04_en
Lowering mower from headland position to working position
„
Unlock the control unit (1+) and move it to the float position until the mower is lowered to the
working position.
„
To mow, move the control unit (1+) to the float position.
Raising mower from working position to headland position
„ Actuate the control unit (1+) until the mower is raised to the headland position.
From headland position to transport position
ü The PTO shaft is switched off.
„
To release the locking (1), tauten the operating cable (2) and keep it tensioned.
„
Actuate the single-acting control unit (1+) until the mower is raised to the transport position.
„
Release the operating cable (2).
KM000-435
„ Close the stop cock (3) on the hydraulic cylinder.
8.5 Mowing
Preparing to mow
ü
All points listed in the chapter "Start-up" have been fulfilled, refer to page 40 .
ü
The machine is in the working position, refer to page 47 .
ü The machine is shut down and safeguarded, refer to page 24 .
ü
The front guard is folded down, refer to page 43 .
ü
The rear linkage is blocked.
ü
The support jack is in the transport position, refer to page 45 .
Mowing
„
Before driving into the crop, engage the tractor PTO shaft at idling speed and slowly
increase the speed to the rated speed of the machine.
„
Drive into the crop.
„ Check the ground pressure while mowing, refer to page 54 .
„
To ensure a clean cutting pattern, adjust the driving and cutting speeds to the prevailing
conditions (soil condition, state of the crop, height, density).