OPERATION
5
25
OPTISENS TSS 2000
www.krohne.com
07/2018 - 4006304401 - OPTISENS TSS 2000 en R01
C3 I/O
C3.3 current out B
Refer to submenus of current output A (all submenus and options are
identical, except that they start with C3.3).
C3.4 current out C
Refer to submenus of current output A (all submenus and options are
identical, except that they start with C3.4).
C3.5 control input
C3.5.1 mode
This function allows to define the
function of the control input. Note
that the actual selection list may be
reduced according to the available
functions.
Options:
•
off: control input is disabled.
•
flow control (only for pH/ORP,
conductivity, free chlorine, chlorine
dioxide and ozone sensors):
process inputs monitor control
input; error level is set to
"application error" if control input
is set, note that ASR is disabled in
this case!
•
all outputs to zero: all outputs
excluding display are set to 0%.
•
hold all outputs: all outputs are
fixed to the current value; a
message of the category "C" is
generated when active, this does
not include the display.
C3.5.2 invert signal
This function allows to define how
the control input is activated.
Options:
•
off: control input is activated when
a voltage > 8 V DC is applied to the
input.
•
on: control input is activated when
no or a low voltage < 2.5 V DC is
applied to the input.
C3.5.3 information
Contains serial number, software
version number and production date
of the circuit board.
C3.5.4 simulation
This function allows to simulate
input values for the control input.
The available options are break and
set value. With set value the
simulation can be set to On and
started with Yes.
Function
Settings / descriptions
