KROHNE OPTIFLEX 8200 C, Руководство пользователя

Страница: 106 / 220

6
OPERATION
106
OPTIFLEX 8200 C/F/S
www.krohne.com 06/2018 - 4006448901 - MA OPTIFLEX 8200 R01 en
How to prepare a strapping table (conversion table)
• After you enter 1.0.0 Advanced Setup
1.0.0 Advanced Setup 1.0.0 Advanced Setup
1.0.0 Advanced Setup menu, push [ ] and [>>>>] to start to the 1.2.0 Conversion
1.2.0 Conversion 1.2.0 Conversion
1.2.0 Conversion
Setup
Setup Setup
Setup procedure.
• Push [ ] and [ ] to find the length unit (m, cm, mm, in or ft) that you will use in the table.
Push [
^
^ ^
^
] to go to the next step.
• Push [ ] and [ ] to find the conversion unit (m
³
, L, gal, Imp, ft
³
, bbl, kg, t, Ston, Lton, m, cm,
mm, in or ft) that you will use in the table. Push [
^
^ ^
^
] to go to the next step.
• Push [>>>>] to make the first point on strapping table.
• The cursor moves to the length value (default value: 0000.00). Push [>>>>] to change the position
of the cursor and then push [ ] and [ ] to change the value of each digit. Push [
^ ^ ^ ^
] to go to
the next step.
• The cursor moves to the conversion value (default value: 00000.000) Push [> >>>] to change the
position of the cursor and then push [ ] and [ ] to change the value of each digit. Push [
^ ^ ^ ^
],
[>>>>] and [ ] to make the second point on strapping table.
• The cursor moves to the length value (default value: 0000.00). Push [>>>>] to change the position
of the cursor and then push [ ] and [ ] to change the value of each digit. Push [
^ ^ ^ ^
] to go to
the next step.
• The cursor moves to the conversion value (default value: 00000.000) Push [>
>>>] to change the
position of the cursor and then push [ ] and [ ] to change the value of each digit. Push [
^ ^ ^ ^
],
[>>>>] and [ ] to make the subsequent point on strapping table. Repeat the last 2 steps to add
more points to the table. If you have a sufficient number of points, push [
^
^ ^
^
] to complete the
procedure.
• Push [
^
^ ^
^
] again and again to go back to the Store Store Store Store screen.
• Push [ ] or [ ] to set the screen to "STORE YES" and push [
^
^ ^
^
].
i The device will store the data for the strapping table and go back to normal mode.
An output agrees with volume measurement when the output function is set to "Level
conversion", "Interface conversion" or "Layer conversion". Menu items related to
volume measurement are:
• 1.3.1 Output 1 Setup and 2.4.1 Output Function I1 (output 1)
• 1.3.2 Output 1 Setup and 2.4.7 Output Function I2 (optional output 2)
• 2.3.1 Tank Height
Figure 6-7: How to make a strapping table in Configuration mode
1 The "+" sign is shown if there are no points on the conversion table. Push [ ] when the cursor is on this sign to add a
point on the table.
2
The conversion table is set to point "2".
3
The position of the cursor shows which digit can be changed