USER’S MANUAL
17
Chapter 5 ADJUSTMENT
Add oil and check the order of phase
.
After installing lift as Picture 4 required and connecting hydraulic circuit and
electric circuit, operate it as following:
-open the hydraulic oil tank, add 12L of hydraulic oil into the oil tank, the hydraulic oil is
provided by the user.
Make sure the clean of hydraulic oil, prevent any impurity into the oil line, lead the
digest of the oil line and no working of the electromagnetic valve.
-Turn the “MAIN SWITCH” to turn on power, and click the ‘UP’ button, check whether
the motor turns clockwise (looking downward), if not press
power
button, change the
phase of the motor.
When turn on power, the high voltage will exist in the control box, only
authorized person can operate it.
No load of main machine test:
-Turn on ‘
MAIN SWITCH
’ to turn on the power.
-Press “
UP
” button, pay attention to the synchronization and placidity of the lifting.
-Check whether lock latch is correctly located.
-Check whether the oil line and the air line are leakage.
When testing the lift, no person or other things are allowed to stand or be put
near the two sides or beneath the machine. If any abnormal is found, turn off
“
MAIN SWITCH
” to stop it immediately. After clearing obstacles, do the test
again.
Load of machine test:
-Drive the vehicle which weight doesn’t exceed maximum lift weight to the platform,
and then the driver leaves it.
-Put the lift rubber on the platform.
-Press ‘
UP
’ button, lift the platform and pay attention to the synchronization and
placidity of the lifting.
-Check whether safety pawl is correctly located.
-Check whether the oil line and the airline are leakage.
When beginning load of machine test, no person or other things are allowed to
stand or be put near the two sides or beneath the machine.
Test vehicle whose weight doesn’t exceed maximum lift weight.
Check whether the oil line and the air line are leakage. If any abnormal is found, urn
off “
MAIN SWITCH
” to stop it immediately. After clearing obstacles, do the test again.