USER’S MANUAL
13
that are not compatible with the capacity of the lift.
When the platform is being tested, the vehicle engine cannot be turned on.
There is nothing should be placed on the lift-lowering area and the movable
parts of the lift.
Chapter 3 SAFETY
RISK OF SLIPPING (Picture 12)
The floor caused by lubricant contamination of around the lift. The area beneath
and immediately surrounding the lift and also the platforms must be kept clean.
Remove any oil spills immediately.
R
ISK OF THE CENTER OF GRAVITY OF VEHICLE
The car Centre of gravity must be placed in the center of the lifting machine (Picture13)
RISK OF ELECTRIC SHOCK
Risk of electric shock of the areas of insulated in electric equipments were
shattered.
Do not use jets of water, steam solvents or paint next to the lift, and take special care
to keep such substances clear of the electrical control panel.
RISKS RELATED TO INAPPROPRIATE LIGHTING
The operator and the maintenance fitter must be able to assure that all the
areas of the lift are properly and uniformly illuminate compliance with the laws
in force in the place of installation.
During up and down operations, the operator should continually observe the lift and
can operate it only in the position of operator. When lifting and lowering the vehicle,
the cushion needs being put in the bottom of chassis.
The handling of safety devices is strictly forbidden. Never exceed the maximum
carrying capacity of the lift, make sure the vehicles to be lifted have no load.
It is therefore essential to adhere scrupulously to all regulations regarding use,
maintenance and safety contained in this manual.
Picture 12
Picture 11
