USER’S MANUAL
15
Picture 15
Chapter 4 INSTALLATION
Platform Installation:
-Place the platforms on the position of the location.
-The bottom of hydraulic cylinder is located in the frontage
of machine (the direction of driving on the vehicle)
-Use fork lift or other lifting equipments to lift the platform
(Picture 15) and insert a wood in the middle part of joint
pole.
Prohibit working beneath the lift when hydraulic
system is not completely equipped with hydraulic oil
and take the action of up and down operations.
LINE CONNECTION
Connect the electrical and oil line according to ‘the electrical diagram’ and ‘oil
pipe connection diagram’.
In the process of connecting oil pipe, pay particularly attention to the protection
of pipe tie-in to prevent abnormal thing from entering oil loop, then damaging
hydraulic system.
ELECTRIC CIRCUIT CONNECTION:
Follow the stated line- pathway and line-number of the ‘electrical diagram’ to connect
electric circuit.
Only skilled person is allowed to perform the operations.
-Open the control box front cover.
-
Connection of power supply:
the
380
V three-phase and five-line
connection wires (3×2.5 mm
2
＋
2×1.5 mm
2
cable wire) for power supply are
connected to control box L1, L2, L3, N and entering-wire terminal. If the lift is operated
at 230V single-phase, then connected to control box L2, N2 ,entering-wire
Terminal.The The PE ground wire is connected under the bolt marked ground firstly
(Picture 16) and then connected under the bolt marked ground of two platforms.
-If the lift is operated at 230V three-phase, change the connection on the transformer
and motor. (Picture 17)
Picture 16
Picture 17
