Krell KAV–2250 and KAV–3250
21
Reconfiguration Options,
continued
Connecting the Amplifier Reconfigured for MAT
1. Connect the cable from your source device to the balanced or single-ended input
you have selected to receive the signal. (For example, if you use the switch settings
shown in Figure 6 your source device is connected to input 1.)
2. Connect each amplifier channel output to a separate loudspeaker.
RECONFIGURING THE AMPLIFIER FOR BRIDGED OPERATION
Reconfiguring the KAV–2250 or the KAV–3250 to Bridge Channels 1 and 2
See Figures 8 and 9 on page 20
To send the signal from a source device connected to input 1,
with channels 1 and 2 bridged:
1. For input switch bank 1, push switch 1 up (on).
2. For input switch bank 2, push switch 1 up (on).
3. Push the bridge switch up (on) between input switch banks 1 and 2.
Notes
Amplifier channels 1 and 2 may be bridged. Channel 3 on the KAV–3250
cannot be
bridged.
The unbridged channel on the KAV–3250
may be connected to a separate loudspeaker
for normal operation.
Connecting the Amplifier Reconfigured for Bridged Operation
1. Connect the cable from the input device to the balanced or single-ended input you
have selected to receive the signal.
2. Connect the positive loudspeaker lead to the red binding post on the corresponding
amplifier channel marked “
BRIDGE
+.” Connect the negative loudspeaker lead to the
red binding post on the amplifier channel marked “
BRIDGE
-.”
IMPORTANT
Tighten binding posts by hand only.
